利用扫描法测量预制棒折射率.pdfVIP

第 36 卷，增刊 Vo1.36 Supp1ement 红外与激光工程 Infrared and Laser Engin础:rins 利用扫描法测量预制棉析射率 周鸿颖 12，陈家璧 1，胡群华 2，邱 高 2 2∞7 年 6 月 Jun.2ω7 (1.上海理工大学光学与电子信息工程学院， 上海 2阴阳93; 2. 东华大学震学院， 上海 2饵)()51 ) 摘要z 通过对现有测试才端的分析，提出了一种新的测量方法一一细光束扫描来测量预制桦的 折射率分布.细光束照射到预制棒上，预制棒就像是拉进镜使光线会聚，光线在预制桦中任过一系 列的折射后，最后从另一端出射.在假定预制棒内折射卒分布的基础上，应用几何光学中的折射定 律对扫描光线进行追迹，计算其在预制棒内的传播路径，得到理论上出射的位置，通过测量可以得 到实际光线出射的位置，利用这两个结果的差异构造评价函数，l:ii用蒙特卡罗算法对假定的折射率 分布进行反复的修正，最后评价品批趋向于一个很小的俑，此时折射牟分布也趋向于其真实分布， 达到测量的目的. 关键词:聚合物光纤; 扫描; 折射卒 中阻分提号: 044 文献栋识码:A 立意捕号: 1∞7-2276(2∞7)增(激光)-0159ω03 Investigation of scan to measure the distributing of refraction ratio of section plane ZHOUHongγing 1气 CI迎N Jia刷刷 1 ， HU Qun-hua 2, Q且JGao2 (1. College of optiω1 Electronic Information En阴阳吨， University of Shan供ai for Science and Technology, Shan如i组刷刷，咄咄 2.Schω10fS即剧，DonghωUniversity， Shan抽血i筑削51 ， China) Abstract: A new measure method is described一-the technique of 也inbωm scanωme副urethe dis回buting of re企Rction ratio of section plane after analyzing measure methods in existence. When 由M beam irradiated section plane, the light is converged 加cause of the section plane like columnar lens. After p础s by a series of refract empress inside section plane，也.e light pass through section plane and out of the other side. Firstly, the distributing of refraction ratio of section plane is supposed. Secondly, the contrail of thin beam with refraction law in geometrical optics b剧创侃出e supposition is calculated. Finally，也e light dipping location of theoretic is obtained. At the same time, the light dipping location of practicality is obtained by experiment. An evaluation function wi由 difference of two result can be constructed. And the supposition of the distributing of refraction ratio of section plane by Monte-Carlo method can be corrected time after time. At last the evaluation function value will get ve叩 little and 出.e distribu山g of refraction ratio of section plane is obtained. Key words: Polymer optical fiber; Scan; 如:fraction ratio .摘自剿I 2007机3