290 Configuring a Catalyst Switch Port Security.pptVIP

CCNA+ 王琳琳 CCNA+ Configuring a Catalyst Switch Port Security Duplex Overview Half Duplex (CSMA/CD) Unidirectional data flow Higher potential for collision Hubs connectivity Full Duplex Point-to-point only Attached to dedicated switched port Requires full-duplex support on both ends Collision-free Collision detect circuit disabled Setting Duplex Options Catalyst 2950 wg_sw_2950(config)#interface fe0/1 wg_sw_2950(config-if)#duplex {auto | full | half} Showing Duplex Options Switch#show interfaces fastethernet0/3 FastEthernet0/3 is up, line protocol is down Hardware is Fast Ethernet, address is 0000.0000.0003 (bia 0000.0000.0003) MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Half-duplex, 10Mb/s input flow-control is off, output flow-control is off ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never Last clearing of show interface counters never Queueing strategy: fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 input packets with dribble condition detected 0 packets output, 0 bytes, 0 underruns 0 output errors, 0 collisions, 2 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier 0 output buffer failures, 0 output buffers swapped out Managing the MAC Address Table Catalyst 2950 wg_sw_2950#show mac-address-table Dynamic Address Count: 1 Secure Address Count: 0 Static Address (User-defined) Count: 0 System Self Address Count: 25 Total MAC addresses: 26 Maximum MAC addresses: 8192 Non-static Addre