PLC步进序控制指令.doc

步进顺序控制指令 我们知道每一个状态都有一个控制元件来控制该状态是否动作，保证在顺序控制过程中，生产过程有秩序地按步进行，所以顺序控制也称为步进控制。FX1S采用状态继电器作为控制元件，并且只利用其常开触点来控制步动作。控制状态的常开触点称为步进接点，在梯形图中用符号表示。 当利用SET指令将状态继电器置1时，步进接点闭合。此时，顺序控制就进入该步进接点所控制的状态。当转移条件满足时，利用SET指令将下一个状态控制元件( 即状态继电器)置1后，上一个状态继电器（上一工步）自动复位，而不必采用RST指令复位。用梯形图表示： 状态转移图用梯形图表示的方法： 控制元件：梯形图中画出状态继电器的步进接点； 状态所驱动的对象：依照状态转移图画出； 转移条件：转移条件用来SET下一个步进接点； 转移方向：往哪个方向转移，就是SET置1的步进接点控制元件。 根据上述所学知识，我们学习步进指令(STL、RET)步进梯形图多分支状态转移图的与梯形图的转换单流程：没有分支的状态转移图称为单流程。 有一个机械动作为图所示.1）按下启动按钮台 车前进，一直到限位开关LS11动作，台车后退， 2）台车后退时，直到限位开关LS12动作，停5秒 后再前进，直到限位开关LS13动作，台车后退； 3）不久限位开关再动作，这时驱动台车的电机停止。 解：图中给出了台车机械动作的过程，分作两次前进和后腿，进程长度不一样。 I/O分配。 输 入 输 出 启动按钮 X0 前进 Y0 停止按钮 X1 后退 Y1 开关LS11 X2 开关LS12 X3 开关LS13 X4 画出PLC接线图 状态转移图程序 leading role, strengthening the capacity of regional radiation. Urban and rural is an inevitable trend, also required from a broader construction of the rapid transit system. Entering the 21st century, the city has maintained fast development momentum, are feature-rich and enhanced. Inherent of city space tends to saturated, in more fast of development speed Xia, city population scale also constantly expansion, city function too concentrated by brings of problem increasingly serious, how Guide City by single center to core-network mode development, by Center City to peripheral group, and tablets District ordered, and efficient expand is future city development must faced of problem, apparently, track traffic for Guide City axis to development, support city space structure optimization and expand has not alternative of role. In 2014, Yibin city peoples Government and the new road bridge stock limited liability company signed the modern streetcar project a strategic cooperation agreement, new road bridge agreement expressly limited shares ... 1.5.1 planning period and long term: as the main planning period to determine future needs of goal nets, planning period to 2030, consistent with the overall urban planning long term life in Yibin city. Vision