Labview串口Word资料-中英文.docVIP

Labview串口Word资料-中英文 先是英文资料，后面有详细的中文资料。/devzone/cda/tut/p/id/2897 Serial Instrument Control Tutorial目录 Overview of Serial Bus Connecting and Setting up a Serial Instrument Control System How to Create a VISA Resource for the Instrument in MAX Instrument Control Software Articles and Related Links Overview of Serial Bus Serial is a common device communication protocol for instrument control because most computers and many remote instruments include at least one serial port. Single applications can be used across a variety of instruments with few modifications, reducing programming and test time. For more information on the serial protocol, including information on transfer speeds and important parameters, please refer to Serial Communication Overview. Connecting and Setting up a Serial Instrument Control System Engineers typically use serial to transmit American Standard Code for Information Interchange (ASCII) data. All data types are converted to strings of ASCII characters and then transmitted bit by bit across the serial bus. For two ports to communicate, both the instrument and the controlling computer must have the same baud rate, data bit size, stop bits, and parity. A basic serial instrument control system consists of four parts: 1. PC 2. Serial cable 3. Serial instrument As mentioned, most computers include a serial port. The only hardware setup required is connecting the serial cable to the serial port on the PC and the serial port on the instrument. The serial instrument may include some hardware drivers or software utilities for communication, and should include documentation on the baud rate, packet size, stop bits, and parity bits that the instrument will use. Additionally, check the National Instruments Instrument Driver Network to see if LabVIEW drivers already exist for yout instrument, as well has tutorials on how to use them. To confirm that the serial port on your computer is working properly, refer to Serial Communication Starting Poi