extreem交换机常用维护命令.doc

extreme 交换机常用维护命令最近有个项目用extreme的网络设备,根据extreme官方资料,整理了一些常用的配置!1.用户名和密码配置create account [admin | user] username {encrypted} {password}configure account admin2.port配置config ports portlist auto off {speed [10 | 100 | 1000]} duplex [half | full] auto off3.Vlan配置无论是核心还是接入层，都要先创建三个Vlan，并且将所有归于Default Vlan的端口删除：config vlan default del port allcreate vlan Servercreate vlan Usercreate vlan MangerDel vlan user定义802.1q标记config vlan Server tag 10config vlan User tag 20config vlan Manger tag 30设定Vlan网关地址：config vlan Server ipa 192.168.41.1/24config vlan User ipa 192.168.40.1/24config vlan Manger ipa 192.168.*.*/24Enable ipforwarding 启用ip路由转发，即vlan间路由Trunk 配置config vlan Server add port 1-3 tconfig vlan User add port 1-3 tconfig vlan manger add port 1-3 tTrunk 删除配置config vlan Server del port 1-3 tconfig vlan User del port 1-3 tconfig vlan manger del port 1-3 t 添加vlan ip configure vlan Server ipaddress 192.168.155.25 255.255.255.252 添加IP ROUTE Config iproute add 删除IP ROUTE Config iproute del4.VRRP配置enable vrrpconfigure vrrp add vlan UserVlanconfigure vrrp vlan UserVlan add master vrid 10 192.168.6.254configure vrrp vlan UserVlan authentication simple-password extremeconfigure vrrp vlan UserVlan vrid 10 priority 200configure vrrp vlan UserVlan vrid 10 advertisement-interval 15configure vrrp vlan UserVlan vrid 10 preempt5.端口镜像配置enable mirroring to port 3 ＃选择3作为镜像口config mirroring add port 1 ＃把端口1的流量发送到3config mirroring add port 1 vlan default ＃把1和vlan default的流量都发送到36.port-channel配置enable sharing port grouping portlist {port-based | address-based | round-robin}7.stp配置enable IS_rtp stpdcreate stpd *configure stpd spanning tree name add vlan vlan name {ports portlist [dot1d | emistp | pvst-plus]}configure stpd stpd1 priority 16384configure vlan marketing add ports 2-3 stpd stpd1 emistp8.DHCP 中继配置enable bootprelayconfig bootprelay add dhcp server ip9.NAT配置Enable nat ＃启用natStatic NAT Rule Exampleconfig nat add out_vlan_1 ma