74AVC4T245 4位数据双向电平转换IC.pdfVIP

1. General description The 74AVC4T245 is an 4-bit, dual supply transceiver that enables bidirectional level translation. The device can be used as two 2-bit transceivers or as a 4-bit transceiver. It features two data input-output ports (nAn and nBn), a direction control input (nDIR), a output enable input (nOE) and dual supply pins (VCC(A) and VCC(B)). Both VCC(A) and VCC(B) can be supplied at any voltage between 0.8 V and 3.6 V making the device suitable for translating between any of the low voltage nodes (0.8 V, 1.2 V, 1.5 V, 1.8 V, 2.5 V and 3.3 V). Pins nAn, nOE and nDIR are referenced to VCC(A) and pins nBn are referenced to VCC(B). A HIGH on nDIR allows transmission from nAn to nBn and a LOW on nDIR allows transmission from nBn to nAn. The output enable input (nOE) can be used to disable the outputs so the buses are effectively isolated. The device is fully specified for partial power-down applications using IOFF. The IOFF circuitry disables the output, preventing any damaging backflow current through the device when it is powered down. In suspend mode when either VCC(A) or VCC(B) are at GND level, both nAn and nBn are in the high-impedance OFF-state. 2. Features n Wide supply voltage range: u VCC(A): 0.8 V to 3.6 V u VCC(B): 0.8 V to 3.6 V n Complies with JEDEC standards: u JESD8-12 (0.8 V to 1.3 V) u JESD8-11 (0.9 V to 1.65 V) u JESD8-7 (1.2 V to 1.95 V) u JESD8-5 (1.8 V to 2.7 V) u JESD8-B (2.7 V to 3.6 V) n ESD protection: u HBM JESD22-A114E Class 3B exceeds 8000 V u MM JESD22-A115-A exceeds 200 V u CDM JESD22-C101C exceeds 1000 V n Maximum data rates: u 380 Mbit/s (≥ 1.8 V to 3.3 V translation) u 200 Mbit/s (≥ 1.1 V to 3.3 V translation) u 200 Mbit/s (≥ 1.1 V to 2.5 V translation) u 200 Mbit/s (≥ 1.1 V to 1.8 V translation) u 150 Mbit/s (≥ 1.1 V to 1.5 V translation) 74AVC4T245 4-bit dual supply translating transceiver with configurable voltage translation; 3-state Rev. 01 — 20 July 2009 Product data sheet NXP Semiconductors 74AVC4T245 4-bit dual supply