PCB传感器正确的安装与拆卸.pdf

1 Practical Sensor Mounting 传感器正确的安装和拆除方法 Jerry Hu 胡爱军 PCB Piezotronics, Inc. ? Established 1967 成立于1967年 ? Located on 6 acres near Buffalo, New York, USA 位于美国纽约布法罗市 ? Specialise in sensors for rapid and steady- state pressure, force, acoustic and vibration measurements 致力于快速和稳态压力、 力、声学和振动测量 ? Represented in over 50 countries 在超过50 个国家设有代表处或分销商 ? AS9100 Certified, ISO 9001 Certified, A2LA Accredited to ISO 17025 AS9100 认证，ISO9001认证，A2LA认证 PCB 公司介绍 PCB的产品线 Signal Conditioner 信号调理器 Industrial Accelerometer 工业传感器 DC Accelerometer DC 加速度计 WFT 六分力传感器 Pressure Transducer 静/动态压力传感器 Miniature Accelerometer 小型加速度计 TORKDISK? 扭矩传感器 Load Cell 载荷称重传感器 Human Vibration Meters 人体振动表 High Sensitivity Microphones 高灵敏度传声器 Sound Level Meters 声级计 Calibration 传感器标定系统 Shakers 激振器 Instrumented Steering Wheel 测力方向盘 Sensor Mounting 传感器安装 4 Mounting with Cyanoacrylate胶结安装 Prior to mounting a sensor with cyanoacrylate, ensure that both the sensor and the mounting surface are free of grease, oil or debris. To do this, use acetone to lift any debris and wipe it away with a clean towel. This ensures clean surface to surface mounting. 在传感器用胶水安装之前，确保传感器和安装面都没有油或灰尘。用丙 酮擦除灰尘再用干净纸巾擦干确保安装面干净。 Clean the sensor 清洁传感器 Clean the mounting surface 清洁安装面 Mounting with Cyanoacrylate胶结安装 Correct – Small dots of glue allow for precise attachment 小的点胶可以达到精密附着 Incorrect – Too much glue can delay setting and cause excess to build up on sides of sensor 过多的胶水会延迟设置时间以 及在传感器周围造成堆积 Mounting with Cyanoacrylate胶结安装 Correct – Make sure the mounting surface is free of debris and dust by cleansing it prior to attachment. Then press sensor to surface for 5 seconds. 确保安装面没有灰尘，压住传 感器到安装面上维持5秒钟 Incorrect – Too much glue can delay setting and cause excess to build up on sides of sensor. Mounting with Petro Wax石蜡安装 Correct – Small amounts of wax in all four corners 正确-传感器四周各点一些蜡 Incorrect – Too much wax will prevent good mechanical c