An Analytic Comparison of RPS Video Repair.pdf

An Analytic Comparison of RPS Video Repair Yubing Wang*a, Mark Claypoolb, and Robert Kinickib aEMC Corporation, 32 Coslin Drive, Southborough, MA 01729, USA bWorcester Polytechnic Institute, 100 Institute Road, Worcester, MA 01609, USA ABSTRACT Transmitting high-quality, real-time interactive video over lossy networks is challenging because network data loss can severely degrade video quality. A promising feedback technique for low-latency video repair is Reference Picture Selection (RPS), whereby the encoder selects one of several previous frames as a reference frame for predictive encoding of subsequent frames. RPS operates in two different modes: an optimistic policy that uses negative acknowledgements (NACKs) and a more conservative policy that relies upon positive acknowledgements (ACKs). The choice between RPS NACK and RPS ACK depends on network conditions, such as round-trip time and loss probability, and on the video content, such as low or high motion. This paper derives two analytical models to predict the quality of videos (using Peak Signal to Noise Ration, PSNR) with RPS NACK and RPS ACK. These models are used to study RPS performance under varied network conditions and with different video contents through a series of experiments. Analysis shows that the best choice of ACK or NACK greatly depends upon the round-trip time and packet loss, and somewhat depends upon the video content and Group of Pictures (GOP) size. In particular: 1) RPS ACK performs better than RPS NACK when round-trip times are low; 2) RPS NACK performs better than RPS ACK when the loss rate is low, and RPS ACK performs better than RPS NACK when the loss rate is high; 3) for a given round-trip time, the loss rate where RPS NACK performs worse than RPS ACK is higher for low motion videos than it is for high motion videos; 4) videos with RPS NACK always perform no worse than videos without repair for all GOP sizes; however, 5) below certain GOP sizes,