Mechanical Properties And Tolerance From ALUMECO.pdfVIP

Mechanical properties Mechanical properties: Plates/Sheets Mechanical properties: Profiles - Alloy EN AW-6060 og EN AW-6082 Mechanical properties: Aluminium bars - Extruded Mechanical properties: Aluminium Bars - Drawn Tolerances Tolerances for Sheets/Plates Width thickness tolerances for Cold-rolled Sheets/Plates according to EN 485-4:2008 Alloy group: I = EN AW-1050A/EN AW-3003/EN AW-5005 II = EN AW-5052/ EN AW- 5754/EN AW-5083/EN AW-6082/EN AW-7075 Width thickness tolerances for Hot-rolled Sheets/Plates according to EN 485-3:2008 Valid for alloy groups I II Flatness tolerances Flatness tolerances for sheets/plates are indicated in the tables down-below and are expressed as a percentage of the length L and /or the width W and/or the measured chord length L. Deviation from flatness is measured as shown in the figures using a lightweight straightedge and a feeler gauge, while the sheet or plate is resting on an horizontal base plate concave side upwards. d = Deviation from flatness l = length of buckle (chord) d = deviation from flatness l = length of buckle (chord) d = deviation from flatness l = length of buckle (chord) Flatness tolerances for hot-rolled sheets/plates according to EN 485-3:2000 Flatness tolerances for cold-rolled sheets/plates according to EN 485-4:2000 Tolerances for Flat Profiles Tolerances for Extruded Flat Profiles EN 755-5:2008 Alloy group I: EN AW-1050A/ EN AW-1350/ EN AW-6005/ EN AW-6012/ EN AW-6060/ EN AW-6082/ EN AW-6262 Tolerances for Extruded Flat Profiles EN 755-5:2008 Alloy group II: EN AW-2007/ EN AW-2011/ EN AW-7075 Tolerances for Square Bars Tolerances for Drawn Square Bars according to EN 755-4:2008 Alloys: EN AW-6060/6063/ EN AW-6012/ EN AW-6262/ EN AW-2011/ EN AW-6082/ EN AW-2007 Tolerances for Extruded Square Bars according to E