电源插头上盖注塑模毕业论文.docVIP

浙江水利水电学院毕业设计（论文） PAGE \* MERGEFORMAT50 毕业设计（论文） 题　　目： 通讯线电源插头上盖模具设计与制造 2013年 5 月 27 日 电源插头上盖注塑模具设计 摘要 本文主要介绍的是电源插头上盖注塑模具的设计方法。首先分析了电源插头上盖制件的工艺特点，包括材料性能、成型特性与条件、结构工艺性等，并选择了成型设备。接着介绍了电源插头上盖注塑模的分型面的选择、型腔数目的确定及布置，重点介绍了浇注系统、成型零件、合模导向机构、脱模机构、定距分型机构以及冷却系统的设计。然后选择标准模架和模具材料，并对注射机的工艺参数进行相关校核。最后对模具的工作原理进行阐述，以及在安装调试过程中可能出现的问题进行总结、分析，并给出了相应的解决方法。 本文论述的电源插头外壳注塑模具采用三板式结构，即浇注系统凝料和制件在不同的分型面脱出，采用一模两腔的型腔布置，最后利用推板将制件推出。 关键词：电源插头上盖；注塑模；三板模；浇注系统；脱模机构；定距分型机构 The mould injection design of Power plug cover Abstract This paper describes the power plug cover injection mold design. The first analyzes the power plug cover parts of the process characteristics, material properties and molding characteristics and conditions, structure, process, etc., and select the molding equipment. Then introduced the power plug cover injection mold parting line selection, determining the number and arrangement of the cavity, focusing on the gating system, molded parts, clamping guide mechanism, pulling mechanism, fixed pitch typing institutions and cooling system design. And then select the standard mold and the mold material and injection machine process parameters check. Finally, the working principle of the mold described, as well as problems that may arise in the process of installation and commissioning summarize, analyze, and gives the corresponding solution. This article discusses the charger shell three-plate injection mold structure, namely the gating system condensate material and parts emerge in different parting surface, using a four-chamber mold cavity layout, and finally the use of the push plate parts introduced. Keyword:Charger shell;Injection mould;Threepence mould;Gating system;Moulding mechanism ; Space parting institutions 目录  TOC \o 1-3 \h \z \u  HYPERLINK \l _Toc358152066 1. 电源插头上盖工艺性分析  PAGEREF _Toc358152066 \h 7  HYPERLINK \l _Toc358152067 1.1 工艺性分析  PAGEREF _Toc358152067 \h 7  HYPERLINK \l _Toc358152068 1.2塑件的结构及成型工艺性分析  PAGEREF _Toc358152068 \h 8  HYP