电力电子装置的谐波分析_毕设论文.docVIP

兰州交通大学毕业设计（论文） -  PAGE II -  PAGE \* MERGEFORMAT I (此文档为word格式，下载后您可任意编辑修改！) 摘 要 近几十年来，由于电力电子装置的广泛应用，公用电网的谐波污染日益严重，由谐波引起的各种故障和事故不断发生，如何有效的计算谐波，检测谐波，抑制谐波和提高电能质量已成为电力系统的一个研究热点。因此，对电力电子装置进行谐波分析具有重要意义。 首先，本文从理论上对带阻感负载的桥式整流电路进行谐波分析，主要包括单相和三相桥式全控、半控和不控整流电路，推导其在忽略换相过程和直流侧电流脉动时交流侧电流中基波和各次谐波有效值的表达式。在此基础上，进一步分析了三相全控桥式整流电路在分别考虑换相过程和直流侧电流脉动时的谐波含量。 其次，以MATLABSimulink软件作为仿真平台，分别搭建了单相和三相桥式可控整流电路的仿真模型，分析了在不同延迟触发角时，交流侧电流中的谐波含量，且将理论计算数据与仿真分析数据进行对比，其误差在可控范围内。结果表明，采用仿真工具，验证了本文理论分析的正确性。 最后，利用MATLAB软件编写了谐波电流计算界面，实现了谐波含量数据的可视化输出。 关键词：桥式整流电路；谐波计算；仿真分析；可视化界面 -  PAGE III - Abstract Harmonics pollution of the utility grid recent years. And it results in power quality drops and accidents . How to effectively restrain resistive inductive load in theory, including single-phase and three-phase full-controlled bridge, semi-controlled and non-controlled rectifier circuit, and it derives the AC side current expression of the fundamental and ignoring for-phase process and the DC current ripple. On this basis, this paper analyzes of the considering the commutation process and the DC current pulse move forward a single step. Secondly, the single-phase and three-phase bridge is built with controlling rectifier circuit simulation model by using MATLABSimulink software as the simulation platform respectively, and analyzes the different delay firing angle of the AC side current analysis of data, the error is in the controllable range. The results show that it is proved the correctness of theoretical analysis by using simulation tools. Finally, it writes the interface by using MATLAB software, and achieves output of the . Key Words：Bridge rectifier circuit, Harmonic calculation, Simulation analysis, Visual interface 目 录  TOC \o 1-3 \h \z \u 摘 要  PAGEREF _Toc327776394 \h I Abstract  PAGEREF _Toc327776395 \h II 目 录  PAGEREF _Toc327776396 \h III 1 绪论  PAGEREF _Toc327776397 \h 1 1.1 论文背景与意义  PAGEREF _Toc327776398 \h 1 1.2 论文研究现状  PAGEREF _Toc327776399 \h 1 1.3 论