泌阳县城市污水厂工艺设计_论文.docVIP

 PAGE \* MERGEFORMAT II (此文档为word格式，下载后您可任意编辑修改！) 摘 要 本次毕业设计的题目为泌阳县城市污水厂工艺设计，主要任务是完成该地区的污水厂设计。 该污水厂的设计规模：30000m3d，本工程设计进水水质为：BOD5=200mgL， COD=420mgL，SS=300mgL，NH3-N=20mgL，TN=40mgL，TP=3.0mgL。根据国家有关规定，二级城市污水处理厂出水应执行《城镇污水处理厂污染物排放标准》（GB18918-2002）一级B标准。则本处理厂出水水质标准为： BOD5≤20mgL， COD≤60mgL，SS≤20mgL，NH3-N≤8mgL，PO4-P≤1mgL。 本文根据其进水水质，水量及出水情况，分析比较了各种污水处理工艺，确定了该污水处理厂采用AAO工艺，产生的污泥经浓缩，脱水后外运。 主要设计内容为：污水处理工艺选择及各工艺单元的设计：污泥处理工艺设计：污水处理厂的平面及高程布置。 关键词：污水处理 AAO工艺 构筑物 工程 设计 河南城建学院本科毕业设计 Abstract  PAGE \* MERGEFORMAT III Abstract The graduation design topic for the Miyang sewage treatment plant process design. The main task is to complete a the region of the sewage processing design. Miyang sewage treatment plant the construction scale: 30000 m3d; The original water: CODCr: 420mgL, BOD5:200mgL; SS: 300mgL; NH3-N: 20mgL; TN:40mgL; TP:3.0mgL for sewage treatment plant emissions standards (GB18918-2002) level 1B standard requirements: CODCrthan60 mgL, more than 20mgL BOD5, SS than 20mgL, NH3-N than 8mgL, TP than 1.0 mgL. In this paper, according to the feed water quality, water and water situation, analyses and compares the all kinds of wastewater treatment process, determine the sewage treatment plant using the AAO process, the sludge produced by the enrichment, sinotrans after dehydration. The main design content includes: choosing the wastewater treatment process and the process of design unit ; The sludge treatment process design, (including process flow and the determination of the monomer structures design); Sewage treatment plants the plane and elevation layout . KEY WORDS: wastewater Treatment, AAO process, construct building,design, engineering 河南城建学院本科毕业设计 目录  PAGE \* MERGEFORMAT VI 目 录 TOC \o 1-3 \h \u 1. 概 述  PAGEREF _Toc21466 1 1.1 项目基本情况  PAGEREF _Toc25576 1 1.2 设计依据与基础资料  PAGEREF _Toc12091