泉州二级公路B段线路设计毕设论文.docVIP

PAGE   PAGE \* MERGEFORMAT 65 (此文档为word格式，下载后您可任意编辑修改！) 摘 要 本次设计主要是泉州二级公路B段线路进行设计，设计的内容主要包括选线、平面设计、纵断面设计、横断面设计、超高设计、挡土墙设计、沥青混凝土路面设计。 为了经济适用，本次设计路基宽度为14m，土路肩0.5m，为了保障排水，路面路拱度2%，土路肩为3%。路堤处设边坡，比例1:1.5，路堑处设边沟，边沟坡度1:1，高度和深度均为0.5m，在深挖的路段另设截水沟截水沟，截水沟坡比、高度和深度同边沟一致。路面采用沥青混凝土路面，又由于该路路面等级高，所承受交通量较重，因此采用三层式结构，即表面层采用4cm厚的细粒式密集配沥青混泥土，中面层采用5cm厚中粒式密集配沥青混泥土，下层面采用6cm厚粗粒式密集配混泥土。 关键词 泉州二级公路 选线 沥青混泥土 Abstract This design is mainly quanzhou secondary roads B section routes for the design, the design of content mainly includes route, graphic design, alignment design, cross-sectional design, ultra-, retaining wall design, asphalt concrete pavement design. In order to economy applicable, the design of roadbed width to 14m, dirt road shoulder 0.5 m, in order to ensure drainage, paving road arch degrees 2%, dirt road shoulder for 3%. Embankment slope, proportion in a 1-1. 5, cutting place set ditches, ditches slope 1:1, deep dig sections another set cut ditch cut ditch, cut ditch slope, with ditches and consistent. Pavement using of asphalt concrete pavement, and because three layers, namely, type structure using intersecting 4cm thick fine-grained type of asphalt mixes clay, dense worthy of using 5cm thick layer of grain of type of asphalt mixes clay, dense match by next level 6cm thick coarse grained type dense matchs mixes clay. Keywords Quanzhou secondary roads route selection Asphalt mixes clay 目 录  TOC \t 弟1,1,弟2,2,弟3,3 摘 要  PAGEREF _Toc295387901 \h I Abstract  PAGEREF _Toc295387902 \h II 第1章 绪论  PAGEREF _Toc295387903 \h 1 1.1总体设计的基本任务  PAGEREF _Toc295387904 \h 1 1.2沿线自然条件  PAGEREF _Toc295387905 \h 2 1.3道路建设的意义  PAGEREF _Toc295387906 \h 2 第2章 公路等级  PAGEREF _Toc295387907 \h 3 2.1交通分析  PAGEREF _Toc295387908 \h 3 2.2主要技术指标  PAGEREF _Toc295387909 \h 4 第3章 道路选线及平面设计  PAGEREF _Toc295387910 \h 6 3.1选线的原则与步骤  PAGEREF _Toc295387911 \h 6 3.1.1选线的原则  PAGEREF _Toc295387912 \h 6 3.1.2选线的步骤  PAGEREF _Toc295387913 \h 7 3.2平面线形设计  PAGEREF