船舶制造英语日常用语选编.doc

船舶制造英语日常用语一．? ? ? ? 船体1．? ? ? ? You must weld and grind this area before painting.在油漆之前你必须把这个地方电焊修补、打磨好。??2．? ? ? ? This welding line should be gouged and welded again before tightness inspection.这条焊缝在密性检查前要碳刨、再焊。3．? ? ? ? The structure of the starboard side is different from the port side.右舷的结构跟左舷的不一样。4．? ? ? ? We should reinforce the downside of the windlass.我们应该在锚机的反面加强。5．? ? ? ? The navigation deck is not plain,??we will fair the deck by hot working.驾驶甲板不平，我们要火工校正。6．? ? ? ? There are two pieces of stiffeners and brackets must be replaced.有两块加强筋和肘板要换新。7．? ? ? ? Two more footrests and handgrips should be installed at the entrance of the small hatchcover. 在小舱口盖的进口处再安装两只踏步和拉手。二．? ? ? ? 轮机1．? ? ? ? Inspection machining dimension of propeller shaft(intermediate shaft or counter shaft).螺旋桨轴（中间轴）机加工尺寸检查。2．? ? ? ? Check for surface contact area(metallic contact) between stern shaft and propeller hub tapers. 检查螺旋桨轴与螺旋桨锥度接触面。3．? ? ? ? Inspection machining dimension of rudder stock.舵杆机加工尺寸检查。4．? ? ? ? Inspection rudder carrier after assembly.上舵承组装后检查。5．? ? ? ? Inspection machining dimension of rudder pintle.舵销机加工尺寸检查。6．? ? ? ? Inspection alignment of stock, rudder blade and pintle.舵杆、舵叶、舵销连接后中心线检查。7．? ? ? ? Lowering test and tension test of anchor.锚投掷试验和拉力试验。8．? ? ? ? Measuring dimension of shaft coupling bolts and reamer hole.轴系连接螺栓和钻孔尺寸测量。9．? ? ? ? Inspection installation correctness of ship’s name plate(funnel mark).船名牌（烟囱标志）安装正确性检查。10．? ? ? ? Flexibility and hosing test for small water tight hatch cover(water tight door and window).水密小舱口盖（水密门、窗）启闭灵活性、冲水检查。11．? ? ? ? Tightness test(opening and closing test,emergency opening and closing test)for cargo hatch cover.货舱舱口盖密性试验（启闭试验、应急启闭试验）。12．? ? ? ? Inspecting anchor throwing away appliance.弃锚装置检查。13．? ? ? ? Inspecting centerline positioning for shaft system and rudder system before boring.轴、舵系镗孔前中心线定位检查。14．? ? ? ? Optical aligned check for shaft system after boring.轴系镗孔后光学校中检查。