SPI接口技术.pptVIP

TMS320F2812串行外设接口Serial Peripheral Interface(SPI);16位AD转换芯片AD7705;AD7705的引脚;AD7705内部结构框图;AD7705转换原理 ;;AD7705片内控制寄存器;通讯寄存器 内容决定下一次操作是对哪一个寄存器进行读操作还是写操作，并控制对哪一个输入通道进行采样。所有与器件的通信都必须先写通信寄存器。上电或复位后，器件默认状态为等待指令数据写入通信寄存器。它的寄存器选择位RS2～RS0确定下次操作访问哪一个寄存器，而输入通道选择位CH1，CH0则决定对哪一个输入通道进行A/D转换或访问校准数据。;0/DRDY—— For a write operation, a “0” must be written to this bit so that the write operation to the Communications Register actually takes place. Once a “0” is written to this bit, the next seven bits will be loaded to the Communications Register. For a read operation, this bit provides the status of the DRDY flag from the part. The status of this bit is the same as the DRDY output pin. R/W ——Read/Write Select. This bit selects whether the next operation is a read or write operation to the selected register.A “0” indicates a write cycle for the next operation to the appropriate register, while a “1” indicates a read operation from the appropriate register. ;其他控制寄存器;#define AD_CS GpioDataRegs.GPADAT.bit.GPIOA2#define AD_CLK GpioDataRegs.GPADAT.bit.GPIOA1#define AD_IN GpioDataRegs.GPADAT.bit.GPIOA3 #define AD_OUT GpioDataRegs.GPADAT.bit.GPIOA4#define AD_REDY GpioDataRegs.GPADAT.bit.GPIOA0#define AD_RST GpioDataRegs.GPFDAT.bit.GPIOF9;程序设计;void main(void) { AD_RST=0; delay1(); AD_RST=1; writeword(0x20);//发送写命令序列 clock register writeword(0x0f);//设置更新频率 writeword(0x10);//set up register writeword(0x40);// while(1) { data = readdata(); data_out = (int)1000*3.0*(data-32768.0)/32768.0; } };void writeword(unsigned int byteword) { unsigned int AD16bit,Token; unsigned char i ; AD_CLK=1; AD_CS=0;//开始 delay1(); Token=0x80; AD16bit=byteword; for(i=0;i8;i++) { if(AD16bitToken) AD_IN=1;//输入数据位 else AD_IN=0; AD_CLK=1; delay1(); AD_CLK=0; delay1(); AD_CLK=1; delay1(); Token=Token1; } AD_C