焊条采购书汇.doc

PURCHASE SPECIFICATION 采购技术条件Doc. No.： UW-09-1Rev.： 0PAGE 1 OF 3 WELDING MATERIAL PURCHASE SPECIFICATION FOR SFA5.1M E4915(E7015) SHIELDED METAL ARC WELDING ELECTRODE E4915（E7015）电焊条采购技术条件 符合SFA5.1M（SFA5.1） JOB NO： 09-U1 工号：09-U1 0REV.DESCRIPTION说明PREPARED BY编制Date日期：APPROVED BY批准Date日期：ZIBO XIANGTIAN CHEMICAL THERMOELECTRIC EQUIPMENT MANUFACTURE CO., LTDPURCHASE SPECIFICATIONDoc. No.： UW-09-1Rev. 0Page 2 Of 3 1. Scope 范围 This specification is prepared for purchasing shielded metal arc welding electrode SFA5.1M E4915 (E7015) for job No. 09-U1 Item (Compressed Air Storage Tank). The procurement details are listed in Table 1. 本采购技术条件适用于工号为09-U1产品（压缩空气储罐）所用SFA5.1ME4915（E7015）电焊条的采购。采购技术要求见表1。 Table 1表1 No. 序号Procurement Details 采购技术要求1231Quantity 数量20kg40kg80kg2Specification 采购标准SFA-5.1MSFA-5.1MSFA-5.1M3Brand 型号E4915E4915E49154Type 类型Low- hydrogen 低氢Low- hydrogen 低氢Low- hydrogen 低氢5Diameter 直径2.5mm3.2mm4.0mm6Unit package W.T 单位包装重量5KG5KG5KG7Manufacture: 制造厂金桥焊材集团 2. Test level 试验水平 Tests and examinations shall meet the SFA5.1M requirements. 试验和检验符合SFA5.1M的要求。 3. Electrode identification焊条标识 A) At least one legible imprint of E4915(E7015) must be applied to the electrode covering as near as practical to the grip end of the core wire but not more than 60 mm from the grip end. 在接近焊条夹持端的药皮上印有清晰的E4915或E7015，印字与夹持端的距离不超过60毫米。 B) The ink use for in printing shall provide sufficient contrast with the electrode covering so that the numbers and letters are legible both before and after normal welding conditions. 印字所用墨水必须与焊条药皮有明显的区别，无论在焊前或焊后都可以明显识别。 4. Packing包装 Electrodes shall be suitably packaged to ensure against damage during shipment and storage under normal conditions. 焊条应有合适的包装，以避免正常条件下的运输和储存对焊条造成损伤。 5. Marking of package包装的标识 The following in