aluminiumalsi10mg-Materialdatasheet.PDF

Material data sheet EOS Aluminium AlSi10Mg EOS Aluminium AlSi10Mg is an aluminium alloy in fine powder form which has been specially optimised for processing on EOSINT M systems This document provides information and data for parts built using EOS Aluminium AlSi10Mg powder (EOS art.-no. 9011-0024) on the following system specifications: - EOSINT M 280 with PSW 3.6 and Original EOS Parameterset AlSi10Mg_Speed 1.0 - EOS M 290 400Watt with EOSPRINT 1.0 and Original EOS Parameterset AlSi10Mg_Speed 1.0 Description AlSi10Mg is a typical casting alloy with good casting properties and is typically used for cast parts with thin walls and complex geometry. It offers good strength, hardness and dynamic properties and is therefore also used for parts subject to high loads. Parts in EOS Aluminium AlSi10Mg are ideal for applications which require a combination of good thermal properties and low weight. They can be machined, spark-eroded, welded, micro shot-peened, polished and coated if required. Conventionally cast components in this type of aluminium alloy are often heat treated to im- prove the mechanical properties, for example using the T6 cycle of solution annealing, quenching and age hardening. The laser-sintering process is characterized by extremely rapid melting and re-solidification . This produces a metallurgy and corresponding mechanical proper- ties in the as-built condition which is similar to T6 heat-treated cast parts. Therefore such hardening heat treatments are not recommended for laser-sintered parts, but rather a stress re- lieving cycle of 2 hours at 300 °C (572 °F). Due to the layerwise building method, the parts have a certain anisotropy, which can be reduced or removed by appropriate heat treatment - see Technical Data for examples. EOS GmbH - Electro Optical Systems Robert-Stirling-Ring 1