Double-thread design on the stability of implant.docVIP

 PAGE \* MERGEFORMAT 7 Double-thread design on the stability of implant [Abstract] Objective resonance frequency analyzer and to compare the histopathological analysis of morphological pairs of trapezoidal screw implants and the classic ‘V’ type screw implants for the initial implant stability and functional stability of the latter part of load. Methods mongrel 12, extraction of mandibular premolar, 3 months after the implant, and then after 3 months healing Across restorative treatment, weight-bearing were killed after 3 months. In the implantation, repair, load 1 month, 2 months and the execution load, respectively Resonance frequency analysis measurements implants stability. Samples taken after execution is made of non-demineralized grinding for morphological analysis. The results of two implant stability at all times was no significant difference, but the experimental group in each period of stability of the implants than in control group, the experimental group implants to restore stability in the post-load faster, weight-bearing 3 months after the experimental group, the bone - implant contact rate (BIC) and peri-implant bone area (BA) is slightly higher than those in the control group, but the difference was not significant. Conclusion pairs of trapezoidal screw implants are conducive to ensuring the stability of the implant in the early and later applied to the superiority of low-density bone would be more pronounced. [Keywords:] implants; thread; stability The effect of dual threads design on stability of implants [Abstract] Objective The aim was to study the effect of dual thread implants upon stability by comparing single traditional thread implants. Methods A total of 24 fixtures (12 dual threads and 12 single thread implants) were placed into edentulous mandible of 12 mongrel dogs, and animals were sacrificed for histomorphometry after loaded 3 months. Stability of implants was measured by RFA regularly.Results There was no significant di