On intrapartum electronic fetal heart rate monitoring the application of the continuity of the value of.docVIP

 PAGE \* MERGEFORMAT 11 On intrapartum electronic fetal heart rate monitoring the application of the continuity of the value of [Abstract] Objective To investigate the electronic fetal heart rate monitoring in pregnant women, the continuity of the application when the value of production. Methods 500 cases of maternal fetal heart rate during labor for a continuous electronic monitoring, electronic monitoring of fetal heart in dealing with labor, delivery mode. The results of reactive NST were selected a total of 500 patients were intrapartum continuity of care, of which 375 cases of natural delivery , forceps delivery in 16 cases, 109 cases of operative delivery; Apgar score 7 points more than 480 patients, 20 cases of 7 points or less; including 3 cases into labor after the fetal heart sound abnormal amniotic fluid polluted cesarean section Ⅱ, score at 4 or less. baseline fetal heart rate variability was significantly reduced or lost, severe variable deceleration, prolonged deceleration, and late decelerations were meconium-stained amniotic fluid occurs, cord entanglement and neonatal asphyxia was significantly higher than other graphics abnormal fetal heart rate monitoring. Conclusion of maternal intrapartum effective guidance for continuous fetal heart rate monitoring for labor treatment, early detection of fetal distress, decided the mode of delivery, neonatal asphyxia, significant for prenatal and postnatal care. [Keywords:] pregnancy; continuity of care; electronic fetal heart monitor Fetal heart monitor to take the form of paper or digital fetal heart rate monitoring, fetal heart rate can be continuously observed, and can simultaneously measure the pressure of contractions. Our hospital since 2001, the fetal monitor for the continuous production process monitoring, the maternal into the active phase of cervical dilation 3cm or more, to give care until fetal monitor the baby is delivered, referred to the whole production process monitoring, this