Recast Ni-Cr ceramic alloys on the hardness of.docVIP

 PAGE \* MERGEFORMAT 12 Recast Ni-Cr ceramic alloys on the hardness of Of: Wang Yinghui with Chung Cheng Hui Qiang Ma Shou Feng Li Xiurong governance [Abstract] Objective To study the repeated casting of the hardness of Ni-Cr ceramic alloys. Methods to separate Ni-Cr ceramic alloys 1, 2, 3, 4, after vacuum pressure casting, respectively 1 to 4 times after casting alloy. using has not been cast alloy (new alloys and cast off 1 to 4 times the hardness of the alloy cast into the casting specimens. hardness of polished samples after a preliminary casting, resin embedded processing and metallurgical polishing hardness made specimens after testing on the micro hardness Vickers hardness value. Results After 1 cast Ni-Cr ceramic alloys compared to 2 to 5 times after casting a combined Jinwei Shi no significant difference in hardness (Pgt; 0.05. Conclusion Ni-Cr ceramic alloys cast can be repeated at least 5 times without causing decrease in hardness. [Keywords:] chromium alloy, nickel, alloys, dental casting technique, the hardness ABSTRACT: Objective To study the effect of recasting on the hardness of the nickel chromium ceramic alloy. Methods The recast nickel chromium ceramic alloys were respectively obtained by recasting the nickel chromium alloy in pressure casting condition for once, twice, 3 times and 4 times. The recast alloys were respectively cast with uncast alloys (new alloys) to produce specimens for hardness testing. The hardness specimens were measured for Vickers hardness in a microhardness tester after initial grounding, resin inlay, and metallographic polishing. Results On the basis of their Vickers hardness, there was no significant difference between the alloys recast for 2 ~ 5 times and those cast for once (Pgt; 0.05). Conclusion The nickel chromium ceramic alloy can be recast for at least 5 times without impairing its hardness. KEY WORDS: chromium alloys, nickel; metal ceramic alloys; dental casting technique; hardness Production