第三章-补充资料[基准].ppt

Chapter 3第二部分 参考面、参考轴;Learning Objectives; 草图基准面的作用; 参考几何特征; 创建新基准面; Creating a Plane Parallel to an Existing Plane or Planar Face and  Passing Through a Point ; Creating a Plane at an Angle to an Existing Plane or a Planar Face; Creating a Plane at Some  Offset From an Existing  Plane or a Planar Face; Creating a Plane On Surface; 创建参考轴; Creating a Reference  Axis Using Two Planes; Creating a Reference  Axis Using Cylindrical  or a Conical Surface ; 创建参考点; Creating a Reference Point at the Center of a Face; 创建参考坐标系 ; 其他拉伸选项 ;Figure B Sketch and the reference face to be selected;Chapter 3; 结束条件(孔); Up To Vertex; Offset From Surface;可以通过用草图线、边或者参考轴来定义拉伸的方向. Note that the entity that you want to use for defining the direction of extrusion should not be drawn on the sketch plane parallel to the plane on which the sketch to be extruded is drawn.; “有选择”轮廓的方法建模;You can also select the model edges as a part of the contour. For example, consider Figure A. This figure shows a line drawn on the top face of a rectangular block. You can use the edges of the top face of the rectangular block that form a contour with the line as a sketch to be extruded, see Figure B. Figure C shows the resulting extruded feature.; 拉伸切除成型;拉伸切除成型对话框的选项:; 方向 1; 在剪切特征中处理多实体;You can select the check box provided on the left of the name of the body to keep that body. The selected body is displayed in green in temporary graphics. Select the bodies to keep and choose the OK button from the Bodies to Keep dialog box. Figure E shows a sketch created for the cut feature. Figure F shows the cut feature created using the thin option and the All bodies option selected from the Bodies to Keep dialog box.; 创建“旋转切除”特征;特征区域的概念; 例 1;Start SolidWorks and start a new part document. Invoke the sketcher environment. Draw the sketch of the front view of the model using the automatic mirroring option to capture the design intent of the model. Add the required relations and dimensi