Draft,-Draft的说明.pptxVIP

- DRAFT; +Draft and－Draft Modifiers: 加斜度和减斜度的修正： The modifiers +Draft and“-Draft are used only when Diameter or Thickness are applied to a drafted cylinder, slab, or slot. 当直径或厚度标注在圆柱，平板或者槽上的时候，通常会用到加斜度和减斜度。 These modifiers are risk management tools which reduce the Tolerance Zone and measurement requirements to a 2D zone at either: 这些修正是风险管理工具，用在减少公差范围和2D图纸测量要求上： The large end of the feature ,if “-Draft” is specified. Or 如果减斜度是说明为最大端的特征。 The small end of the feature ,if “+Draft” is specified. 如果加斜度是说明为最小端的特征。 ; +Draft and－Draft Modifiers:(continued) 加斜度和减斜度的修正：（续） The modifiers should not be used only when tight Tolerances or critical function is a requirement. when +Draft and－Draft is used the remaining feature geometry must be controlled by some other means such as a general note which applies a relatively loose surface profile tolerance to any features which are not explicitly toleranced. 此修正不可以用在紧密公差或重要功能要求的地方。当加斜度和减斜度用在其余的几何特征时必须标注一般性的附注：如在没有注明公差范围的地方，标注相对较大的面轮廓度的公差。