9-997_L 耐蚀钢钝化.docVIP

——————————————————————————————————————————————— 9-997_L 耐蚀钢钝化 Rev. L SPECIFICATION Amphenol Corporation Sidney, New York 9-997Page 1 of 8 U “SEE WARNING NOTE” FINISH PASSIVATING OF STAINLESS AND CORROSION RESISTANT TYPE STEEL FSCM NO. 77820 REV. LETTER ISSUE NUMBER ORIGINATOR DATE APPROVAL L B3114 P. FRISCH 2-8-12 Document Origination (Amphenol) PREPARED BY: ENGINEER IN CHARGE: DESIGN MANAGER: DESIGN ACTIVITY GROUP: DATE: Mark Barnes Alan Davis Alan Davis Plating / Sept. 2005 September 13, 2005 Eng’r Form: SC-933 Revised 10/8/10 IMAGED / Mar . 09 2012, 1:27 AMPHENOL CORPORATION Sidney, NY 13838 9-997 Rev. L FSCM NO. 77820 Page 2 of 8 1.0 1.1 2.0 2.1 2.2 This specification pertains to the passivating of stainless and corrosion resistant steels to promote corrosion protection by removing surface contamination. The following specifications of the latest issue in effect on date of issuance forms a part of this specification to the extent specified herein: MIL-STD-171 Finishing of Metal and Wood Surfaces ASTM B254 Standard Practice for Preparation of an Electroplating on Stainless Steel ASTM A380 Practice for Cleaning and Descaling Stainless Steel Parts, Equipment and Systems ASTM A967 Chemical Passivation Treatments for Stainless Steel Parts, Standard Specification SAE AMS 2700 Passivation of Corrosion Resistant Steels 2.3 2.4 9-4590 Electropolishing 300 Series Stainless Steel, Procedure for 3.0 3.1 3.1.1 Parts shall be thoroughly cleaned of oil, grease, and dirt as well as any forming, drawing, cutting and grinding compounds using suitable thinners, degreasers, solvents or cleaners. 3.1.2 If, after cleaning, parts show evidence of rusting or heat treat scale, they shall be further cleaned with permanganate solutions, inorganic acids,