GSM信令疑难问题描述.ppt

* B72 11+1 per RACK 8版是否支持满架配置？ JAE1 appliques : JAE1 applique interfaces up to 16 PCM links for Ater and Gb interfaces a JAE1 has an associated JBGPU board through a PAB (Primary Access Bus) the JAE1 appliques are connected together through a RAB (Redundancy Access Bus) JBGPU boards : set of boards used to process GPRS functions the number of GPUs depends on the processing capacity expected for the MFS each JBGPU board is associated with a JAE1 applique via a PAB (Primary Access Bus) the JBGPU boards are connected to the Ethernet hubs through 2 Ethernet appliques JBETI boards : boards used to manage GPU boards, sub-rack environmental alarms JBETI board is connected to the Ethernet hub via a JBETI applique an ISL bus (Inventory Serial Link) is used to collect board and applique alarms JBETI board handles external alarms, and sends external alarm settings 2 JBETI boards are used, operating in active/standby mode, for each telecom sub-rack GPU boards (GPRS Processing Unit) connected to the redundent LAN : support GPRS telecom functions multiple GPUs are needed to fit with performance requirements ETI boards (Ethernet - ICL/ISL gateway) connected to the LAN : collect infrastructure alarms within the telecom sub-system multiple ETIs are needed for service continuity * ON the front panel of the GPU PBA are: Two reset buttons: S1:-hard reset .all hardware is reset except the NGISL S2:-soft reset. Only the on-board PowerPC is reset Two LEDs the LEDs are contled by the firmware during booting and by the software when the software is downloaded. * GPU (GPRS Processing Unit) ? specific board which performs GPRS functions for the BSS : Ater Gb interface functions GPRS data transfer functions Radio resource management functions GPRS mobility management functions (paging) GPU board environment, within the MFS, is (in a simplified view) as follow : PCM links for external interfaces : Ater interface with the BSC Gb interface with the SGSN Ethernet links for intern