磁流变传动装置温度特性研究 .pdfVIP

学兔兔 第33卷 第3期 仪 器 仪 表 学 报 Vo1．33 No．3 2012年3月 Chinese Journal of Scientific Instrument Mar．2012 磁流变传动装置温度特性研究水 田祖织，侯友夫，王囡囡 (中国矿业大学机电工程学院 徐州 221008) 摘 要：基于热传导理论，采用有限元方法对磁流变传动装置温度场进行了研究，并采用实验方法分析了温度对磁流变传动装 置性能的影响规律。研究发现，该传动装置稳态滑差功率可达200 W，温度最低点出现在传动轴轴端处，最高点则出现在传动 圆盘内外径之间，各点温度分布较为均匀；瞬态时，传动圆盘径向各处温差最大值达到80℃，热变形对微问距传动影响较大， 现场实验温升曲线与有限元分析基本一致；温度升高降低了磁流变液的动屈服应力，但由于磁路磁阻及挤压增强效应影响，可 以轻微提升磁流变传动装置的传力性能。 关键词：磁流变液；温度；磁流变传动；有限元 中图分类号：TB381 文献标识码：A 国家标准学科分类代码：460．40 Study on temperature properties of magnetorheological transmission device Tian Zuzhi，Hou Youfu，Wang Nannan (College of Mechanical and Electrical Engineering，China University of Mining and Technology，Xuzhou 221008，China) Abstract：Based on heat conduction theory，the temperature field of magnet0rhe0l0gical transmission device is stud- ied using finite element method，and the influence rule of temperature on torque transmission properties is analyzed using experiment method．The result indicates that the slip power is 200W，the minimum temperature appears at the end of the axis and the maximum temperature appears at the points between the inner radius and outer radius of the disk．and the temperature distribution of the whole device is uniforrn．The maximum transient temperature difference is 80。C，and the effect of thermal deformation on the micro—working gap is quite great；the result of finite element analysis is the same as that of the experiment．The temperature rise can reduce the yield stress of magnetorheological fluid，and improve the torque transmission slightly beca