物资仓储办法试行.doc

渤海石油装备制造有限公司 物资仓储管理办法（试行） 第一章 总则 为了加强渤海石油装备制造有限公司（以下简称“公司”）物资仓储管理，提高物资仓储管理水平，实现仓储物资的科学管理，依据集团公司有关制度、规定，制定本办法。本办法适用于公司各单位、机关各处室检验检验式。必须或露天存放”，做到“四号定位”、主副货位对应、料签或标牌齐全准确。 第四节 保管保养 物资管理人员对库存物资进行检查和维护保养做好物资维护保养记录。 要严格物资出库管理。门卫值班人员必须严格对照出门证，认真核对出库物资和出库手续，在确认无误后，方可准许出库。 第六节 化学危险品管理 按照GB13690《化学品分类和危险性公示 通则常用化学化学危险品贮存通则 position for future reference. Installation using special lifting pole rotor 6.4.4.6 rotor lift, box spirit level to check the rotor axis neck of Yang, on both sides of the rotor should be lateral raises and numerical deviation of ≤ 0.10MM, qualified before the official lifting. Hoisting of the rotor dynamic and static clearance should be measured, rotors check clearance to prevent rotor colliding. 6.4.4.7 stationary blade carrier, diaphragm and sealing upper cylinder on the inside and install the mounting bolts, bolts and bolt holes in the surface should be coated with molybdenum disulfide. Follow the manufacturers stamp marked to install good sealing ring and spring. Check the sealing ring and spring plate, shall conform to the technical requirements manufacturers drawings. Bolt: ... Measurement with measurement tools, special tools, temporary connection bolts and connection tool equipped and in good condition. The rotor shaft to have fixed, such as thrust, bearing plates fixed installation, in case of wear of the rotor is too large. The coupling gasket check measurements: measured data processing according to gasket, clean the coupling gasket surface clean and Burr-free, check the coupling gasket thickness data, shim thickness deviation of ≤ 0.02mm, parallel degree deviation of ≤ 0.02mm. Coupling temporary bolts ready: preparing 4-8 bolt diameter coupling bolt hole diameter 0.5-1.0mm. 6.4.5.2 shaft coupling 6.4.5.2.1 General requirements in both the relative position of the flange according to the manufacturers mark, if there is no mark, two flange scoop bias complement each other and take care of the bolt hole alignment, hit the mark as