混凝土砌体-2设计原则-20100311-E.pptVIP

Chapter 2  Design theory of masonry structures 2.1 Review of the design method of masonry structures (砌体结构设计方法的历史回顾) 2.2 Determination of the coefficient (分项系数的确定) welcome to use Please learen this carfuely 2.1 Review of the design method of masonry structures 2.1 Review of the design method of masonry structures 2.1.1 Allowable stress design method 容许应力设计法 2.1.2 Failure stage design method 破坏阶段设计法 Limit state design method 极限状态设计法 2.1.3 Limit state design method expressed with three coefficients 三系数表达的极限状态设计法（ 1956年后） 2.1.4 Limit state design method expressed with many coefficients 多系数分析总系数表达的极限状态设计法（GBJ3-73） 2.1.5 Limit state design method expressed with partial coefficients 以分项系数表达的极限状态设计法（GBJ3-88） 2.1.6 Design method of the code for design of masonry structures 现有砌体结构设计规范的设计方法（GB50003-2001） 2.1.1 Allowable stress design method 2.1.2 Failure stage design method 2.1.3 Limit state design method expressed with three coefficients 2.1.3 Limit state design method expressed with three coefficients 2.1.4 Limit state design method expressed with many coefficients 2.1.4 Limit state design method expressed with many coefficients 2.1.5 Limit state design method expressed by partial coefficient 2.1.5 Limit state design method expressed by partial coefficient 2.1.6 Design method in the “Code for design of masonry  structures” （GB50003-2001） In 2002, Code for design of masonry structures was published.（GB50003-2001） The two main revised contents are listed as following: 1.Important coefficient and design working life are corresponding. 2.Composite expression composed mainly of gravity load effect is replenished and the reliable degree of the masonry structure is appropriately adjusted on the basis of the “Unified standard for reliability design of building structures ” GB50068 2.1.6 Design method in the “Code for design of masonry structures” 2.2 Definition of