墙纸裱糊施工方案（七）.docVIP

墙纸裱糊施工方案（七） 墙纸裱糊施工方案（七）提要：施工工艺①墙面抹灰已完成，且干透，含水率不高于8%，木制品含水率不高于12%；②各种水电设备到位，木饰油漆完成等； 源自管理资料 墙纸裱糊施工方案（七） 1、质量要求 ①墙纸品种、性能、规格、颜色、必须符合设计要求，及附有产品合格证明。 ②墙纸必须粘贴牢固，无空鼓、翘边、皱折等缺陷。 ③表面平整，无起伏波纹、无缝隙、色泽一致。 2、材料要求 ①墙纸的质量符合设计使用要求，附产品合格证。 ②成品粘合胶粉，附产品说明书及合格证。 ③石膏粉，大白粉，羧甲基纤维素，107胶等，符合国家质量标准的规定。 ④底层涂料。 3、施工工艺 ①墙面抹灰已完成，且干透，含水率不高于8%，木制品含水率不高于12%； ②各种水电设备到位，木饰油漆完成等； ③将墙面清扫干净，提前修补抹平墙面凸凹不平及缺角处； ④墙面满刮腻子一遍，腻子干后打磨砂纸，完成后二遍、三遍直至腻子基层阴阳角线通畅，顺直，无裂痕、崩角、无砂眼、麻点、无缝隙。 ⑤底层涂刷涂料，基层处理后涂刷一遍涂料，均匀，不得漏刷； ⑥弹线，按墙纸尺寸合理安排墙纸，并从墙角（阴）角弹出垂直；。 ⑦按墙面高度尺寸计算用料，裁纸，按所量尺寸预留边2-3cm余量； ⑧粘贴墙纸时，用湿润毛巾清扫墙纸背面，在墙纸背面及墙面部位刷胶，然后按弹好直线粘贴墙纸，铺贴时由上至下用刮板轻刮，压实，随后用直钢尺压角处拉直，裁边，最后用湿毛巾擦净胶痕，依次进行裱糊。 ⑨墙面上遇有电开关、插座盒时，应在其位置上破纸做标记。 4、检查及注意事项 ①墙纸铺贴后，应仔细检查，对墙纸的翘角、气泡、皱折、胶痕应即使处理和修整，使之完善。 ②墙纸与墙纸交接边顶部及脚线边，应用直钢尺压实，用墙纸刀切割整齐，一次完成，避免皱折，搭口起丝影响美观。 ③选用墙纸品牌应注意其产品使用说明，了解墙纸的膨胀、收缩率。 源自管理资料 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assis