液压滑升设备安全操作规程（六）.doc

液压滑升设备安全操作规程（六） 液压滑升设备安全操作规程（六）提要：千斤顶应经12mpa以上的耐压试验.同一批组装的千斤顶在相同载荷作用下，其行程应一致，用行程调整帽调整后，行程允许误差为2mm 液压滑升设备安全操作规程（六） 一、应根据施工要求和滑模总载荷，合理选用千斤顶型号和配备台数，并应按千斤顶型号选用相应的爬杆和滑升机件. 二、千斤顶应经12mpa以上的耐压试验.同一批组装的千斤顶在相同载荷作用下，其行程应一致，用行程调整帽调整后，行程允许误差为2mm. 三、自动控制台应置于不受雨淋，曝晒和强烈振动的地方，应根据当地的气温，调节作业时的油温. 四、千斤顶与操作平台固定时，应使油管接头与软管连接成直线.液压软管不得扭曲，应有较大的弧度. 五、作业前，应检查并确认各油管接头连接牢固，无渗漏，油箱油位适当，电器部分不漏电，接地或接零可靠. 六、所有千斤顶安装完毕未插入爬杆前，应逐个进行抗压试验和行程调整及排气等工作. 七、应按出厂规定的操作程序操纵控制台，对自动控制器的时间继电器应进行延时调整.用手动控制器操作时，应与作业人员密切配合，听从统一指挥. 八、在滑升过程中，应保证操作平台与模板的水平上升，不得倾斜，操作平台的载荷应均匀分布，并应及时调整各千斤顶的升高值，使之保持一致. 九、在寒冷季节使用时，液压油温度不得低于10℃;在炎热季节使用时，液压油温度不得超过60℃. 十、应经常保持千斤顶的清洁;混凝土沿爬杆流入千斤顶内时，应及时清理. 十一、作业后，应切断总电源，清除千斤顶上的附着物. Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent mo