给排水安装应注意的质量问题.docVIP

给排水安装应注意的质量问题 给排水安装应注意的质量问题提要：给水立管距墙：管径32mm以下距墙25～35mm；管径32～50mm距墙30～50mm；管径75～100mm距墙50mm；管径125～150mm距墙60mm 更多精品源自制度 给排水安装应注意的质量问题 厨卫间立管穿楼板地面处应做出20～50mm水泥台以防止管根积水。 在熟悉图纸的基础上，统计列出需用材料的规格型号、材质、数量，同时考虑损耗用量。在合格物资分承包方名录内优选供货厂家，填写在材料计划单上，同时填写清楚验收标准及供货日期。洞门留置根据图纸审核的结果，绘出管道布置图。在混凝土楼板、墙体浇筑前，设置套管留洞，并固定结实防止移位。 管道距墙：给水支管外皮距墙20～25mm。 给水立管距墙：管径32mm以下距墙25～35mm；管径32～50mm距墙30～50mm；管径75～100mm距墙50mm；管径125～150mm距墙60mm。 管与管关系：给水引入管与排水出户管水平净距不得小于l米；给水与排水管平行铺设，两管水平最小净距为米；交叉铺设垂直净距为米，给水应在排水上，若给水管在排水管之下铺设应加套管，其长度不小于排水管径的6倍。 冷水立管中心间距为≥80mm。 活接头安装：埋设管道不得使用活接头、法兰连接；给水立管出地面阀门处，需装活接头；给水装有3个及以上配水点的支管始端，均装活接头；活接头的子口一头安装在来水方向，母口一端安装在去水方向。 管道变径不得采用补心，使用变径管箍连接；变径管箍安装位置距三通分流处200mm。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education c