锻钎机安全操作规程技术交底2.docVIP

锻钎机安全操作规程技术交底2 锻钎机安全操作规程技术交底2提要：安装模具时，应调整好锤头行程。装换零件、模具或工具时，应先将压缩空气关闭，塞好安全塞，在未塞好塞铁前，严禁将手伸入 于 锻钎机安全操作规程技术交底2 工程名称： 施工单位： 设备名称：锻钎机 作业内容： 交底部门：交底人：施工期限：年月 日 至 年月 日 接受交底班组或员工签名： 交底内容： 1.锻钎机的地基应牢固，周围的地面应平整、清洁，在作业范围内不得放置与作业无关的物件。 2.在连接输气管前，应先将管内积水、污渣吹净，输气管应放在适当的位置，供气压力应符合要求。 3.作业前，应检查受振部分无松动，钎模及工具无破裂，润滑油面符合规定。 4.安装模具时，应调整好锤头行程。装换零件、模具或工具时，应先将压缩空气关闭，塞好安全塞，在未塞好塞铁前，严禁将手伸入。 5.操作时，应轻推手阀，不得使锤头空击或击打空模。 6.锻压或割长钎时，不得碰伤配合人员。吹孔时，配合人员不得正对钎孔。 7.淬火时，钢钎应竖立牢靠。用机油淬火时，应在室外进行。 8.作业中，不得进行任何清扫和检查工作，不得用手去清除工作台上、模具上的铁屑。 9.停机时，应将钎模缓慢合拢，然后停止运转、关闭阀门。 10.作业完毕后，应熄灭炉火，切断电源，并用垫铁垫好锤头。 补充作业指导内容： 于 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and management system, the const