8.13.ansys非线性剖析实例(GUI操纵方法)(国外英文资料).docVIP

8.13.ansys非线性分析实例(GUI操作方法)(国外英文资料) 8.13. Nonlinear analysis instances (GUI operation methods) This example is a nonlinear analysis of the elastic-plastic disc in the case of static load and cyclic loading. You can customize the relevant options for a plastic-dependent curve and load step, including the maximum and minimum values of the load steps, and the external load values applied. In this process, you can learn how to read, and then write the monitoring files generated in the process of nonlinear analysis. The program using incremental solving process to get the solution of nonlinear analysis, in this case, the outside of the total load applied, is by a load of step load steps in turn increase. The process USES the newton-lapes iterative process to solve each step. Process, you must be determined for each load step load steps, because the load steps the child, is used to control is applied to each load step the first step is the size of initial load increment. In addition, the program can automatically determine the size of the load increment for each step in a load step. Of course, you can specify the maximum and minimum values of the load step to control the size of the load increment in these steps. If you define the payload substeps, the largest and smallest number of these substeps are the same. And in the load step, the program USES a constant value as the load increment for each step. 1 problem description The axisymmetric model of the round board is set up with a flat 4 node 182, and the axisymmetric option is set to classify the grid for the model. The geometric analysis was chosen. And set the following exercise constraints: hold the center of the disk at the center of the disk, and make its radial displacement zero. The nodes on the outer edge of the displacement disk have zero radial displacement and zero axial displacement. In the first load step, a static load is applied, and the cyclic point load is applied in the subsequent six load steps. Look