ansys愚昧(国外英文资料).docVIP

ansys屈曲(国外英文资料) Repeat until the magnification of the eigenvalue instability is equal to 1. And then the external load on the structure is the actual eigenvalue loss of the load. And it doesnt contradict the internal forces. The command flow for iterative computing is as follows: ! Set the maximum iteration 100 times * to DO, I, 1100, FINISH / SOLU ! New load is applied to the structure Fk1 - FK, 2, FZ - FORCE ! Static analysis ANTYPE, 0 ! Set the time step 1 TIME, AUTOTS, 0 NSUBST, 1, 1 SSTIF, ON SOLVE FINISH ! Conduct eigenvalue instability analysis / SOLU ANTYPE, BUCKLE! Buckling analysis BUCOPT, LANB, 1! Use Block Lanczos solution method, extract 1 mode MXPAND, 1! Expand 1 mode shape PSTRES, ON! The INCLUDE PRESTRESS EFFECTS SOLVE FINISH ! To get the current eigenvalue instability first order frequency (magnification) * GET FREQ1, MODE, 1, FREQ * IF, (FREQ1-1), LT, 0.01, THEN! If the frequency error is less than 1%, the loop is withdrawn * the EXIT * ENDIF The FORCE = FORCE * FREQ1! Otherwise, the load times the new magnification ratio is calculated again * ENDDO (25) after repeating the above process, the structure of real eigenvalue buckling load of 198174 n, visible if does not exclude the prestressed internal force of the influence of the geometric stiffness matrix, calculated the eigenvalue buckling load (118602 n) are much smaller. (26) finally, we do nonlinear buckling analysis. The buckling load of eigenvalue instability is actually the upper limit of the ideal material for ideal components. Due to the initial defect or non-linearity of the material, the loss of the stability load is usually smaller than that of the eigenvalue. Therefore, nonlinear instability analysis is necessary. In nonlinear instability analysis, the initial defects are introduced. The choice of initial defect is a lot, and it is more commonly used to put the eigenvalue of the structure as the worst initial defect in the structure. The UPGEOM command is provided in ANSYS, which can