公路养护工实际测验试题(国外英文资料).docVIP

公路养护工理论考试试题(国外英文资料) Maintenance work level 3 The road route is () on the plane. A, line B, lower grade C, vertical curve D, line peace curve The number of lanes on the highway should be at least (). A, 2 lane B, 4 lane C, 6 lane D, driveway 3, the 3rd level highway is able to adapt to the annual average daily traffic volume of various vehicles (). A, 15,000 to 30,000 B, 5,000 to 15,000 C, 2,000 ~ 6000 cars D, 1000 ~ 4000 cars The ratio of high and horizontal distances between two points in the same slope of the line section is called (). A longitudinal grade B slope C slope D flat slope 5, to offset the vehicles on the curve road, generated by the centrifugal force in the cross section of setting the () of the one-way cross-sectional slope, called super A medial above lateral B lateral higher than medial middle C high low D inside and outside the same on both sides A curve of continuous variation between a straight line and a curve is called (). A flat curve, B complex curve, C, curve D back In order to facilitate the driving, the limitation of slope length must be carried out in order to facilitate the driving. The radius of the smaller B is larger and the larger D vertical curve is larger Higher than the road base called (). A road block B road C, C levees D half A half way To get the other person to pass through the road on a bicycle, the road surface should be widened at a certain distance, which is a part called (). A overtaking lane B is in the wrong lane In order to make the upper and lower slopes smooth, a circular curve is inserted between the upper and lower slopes, which is called (). A flat curve B, curve C, curve D The projection onto the horizontal surface of the highway is called the highway route. A, B, C, cross section D, longitudinal When calculating the speed of the vehicle is greater than 60km/h, the minimum linear length between the same direction curve is not less than the speed of the vehicle (). A, 4, B, 5, C, 6, D, 7 There are two ways in w