剪力墙基础请求(国外英文资料).docVIP

剪力墙基本要求(国外英文资料) The basic requirements of the shear wall design (excerpt from a chapter of the high gauge shear wall) 7.1.9 seismic design, the bottom of the shear wall structure strengthening highly desirable wall limb of the 1/8 of the total height and the bottom two layers of the larger value of the two, when the shear wall height more than 150 m, the strengthening part at the bottom of the highly desirable wall limb 1/10 of the total height; The height of the strengthening part of the shearing force wall shall be in accordance with the provisions of article 10.2.4 of this regulation. 7.2.15 one, the seismic design of the secondary shear wall at the bottom of the strengthen part and a layer of wall limb end should according to the requirements of this code article 7.2.16 binding edge artifacts; One, the other parts of the seismic design of the secondary shear wall and three or four seismic design and seismic design of shear wall wall limbs end shall be according to the requirements of this code article 7.2.17 set structure edge artifacts. The vertical and horizontal bar of the high building shear wall should not be used in single-line reinforcement. When the thickness of the shear wall is not greater than 400mm, a double rib is used. When bw is greater than 400mm, but no more than 700mm, use three lines of reinforcement; When bw is larger than 700mm, use four lines of reinforcement. The force bar can be evenly distributed into several rows. Each row of distribution of the pull between rebar spacing should not be greater than 600 mm, should not be less than 6 mm in diameter, strengthen the parts in the bottom, outside edge constraint component of joint spacing should be proper encryption. 7.2.16 1 the length of the edge constraint component along the direction of wall limb lc and stirrup stirrup characteristic value should meet the requirements of the table 7.2.16 lambda v and a, level 2 seismic design stirrups should not be less than 8 mm diameter, stirrup spaci