带传动选择(国外英文资料).docVIP

带传动选择(国外英文资料) Page 1 The transmission capacity of the belt is related to the Angle of the package. A (tension wheel) B (large band) C (small band wheel) The belt drive relies on ____ to carry out the movement. A (the driving force of the main shaft) C (the torque of the active wheel) If the transmission ratio of the transmission is 1, the open belt round belt Angle ____. A (= 180 °) B ( 180 ° C (180 ° ) 4, in V belt drive, tape the theory of cross section Angle ____40 °. A () B () C (=) Page 2 5, V pulley groove Angle ____40 °. A () B (=) C () The nominal length of the normal V belt is _____ length. A (inner week) B (reference) C (peripheral) In the same condition, the transmission capacity of v-belt drive. A () B (=) C (). If the belt speed exceeds the allowable value, the driving capacity is ____. A (decreased) B (increased) C (the same) Page 3 The open belt of the I = 1, if the center is larger, the small belt Angle ____. A (decreased) B (increased) C (the same) 10, the transmission can only be open. A (V) B (flat band) C (belt) In order to reduce the bending stress of V belt and prolong the service life, the diameter of the V belt wheel should be the minimum diameter of the wheel. A () B (=) C () The wheel slot of the v-belt wheel is ____. A (32 °) B (34 °) C (36 °) D (40 °) Page 4 A flat belt drive with no tensioning wheel or slanting, and the loose side is suitable for ____. A (above) B (below) (below) C (on either side) The flat belt drive of the plumb line, the loose side can be placed in the ____. A (bottom) B (above) (above) C (on either side) The flat belt can be driven by ____. A (any three) B (open) C (cross) D (half cross) The V belt of a ____ structure should be chosen for occasions where the payload is small, the diameter of the wheel is small and the speed is higher. A (line) B (cord) Page 5 The general drive optional v-belt of the ____ structure. A (line) B (cord) The v-belt model is chosen according to ____. A (the rated power of transmission and