安定宝协议.doc

---！！！！！！----------------------------------精品文档，值得下载，可以编辑！！！-----------------------------！！！！！！----------- ---！！！！！！----------------------------------精品文档，值得下载，可以编辑！！！-----------------------------！！！！！！----------- ------------------------------------------------------------------------- Ademco Contact/Point ID Format Bulletin 1032 1/11/01 Copyright (C) 1999, Coastal Security Systems, Inc. All Rights Reserved ------------------------------------------------------------------------- This format contains a four digit account number, a three digit alarm code which is pre-defined by Ademco, a pin status which can either be alarm or restore, a two digit area number and a three digit zone or user number. It can be depicted as follows: AAAA P CCC XX ZZZ where AAAA is the account number, P is the pin status (alarm or restore), CCC is the alarm code which is pre-defined by Ademco (you cannot program it), XX is the dialer group, partition or area number, and ZZZ is the zone or user number. The central station computer decodes contact id signals and provides the central station operator with default alarm handling instructions which are fully described below. If you are satisfied with the default instructions you need not furnish any signal information for the account. If you wish to modify the default instructions you need only furnish information for the signals you wish to modify. It is mandatory that the subscriber record contains the correct dispatch agencies for police, fire and medical alarms. If the account contains NFPA in the permanent comments field, then FIR, TAM, SUP, and TBL signals are handled as follows and not according to the tables below: FIR send fire agency, send 1 hour dealer runner, notify callout, verify TAM verify, send 1 hour runner SUP verify, send 1 hour runner TBL send 4 hour runner Note that the verify step for an NFPA FIR signal is for notification to the