光电式脉搏传感器的道理和结构(国外英文资料).docVIP

光电式脉搏传感器的原理和结构 1 the introduction Human ventricular systolic and diastolic periodically lead to aortic systolic and diastolic blood pressure in the form of a wave from the aortic root spread along the arterial system, this kind of wave called a pulse wave. Presented by pulse wave form, strength, speed and rhythm of comprehensive information, to a large extent reflects the human body blood flow to the cardiovascular system in many physiological and pathological characteristics. The traditional pulse is measured by way of pulse, pulse condition of traditional Chinese medicine diagnosis technology is the pulse measurement in successful application on the doctor of traditional Chinese medicine, but is affected by human factors is bigger, measurement accuracy is not high. Noninvasive measurement (noninvasive measurements) is also called the non-invasive measurement and indirect measurement, detection part of its important characteristics is measured not invade the body, do not cause the body wounds, usually in vitro, especially in the surface of the indirect measurement of the human body physiological and biochemical parameters [1]. Biomedicine sensors are a key device that takes biological information and turns it into an easy way to measure and process signals. Photoelectric pulse sensor based on photoelectric displacement law into pulse sensor, through to the ends of the fingers transmissivity monitoring, indirectly detect the pulse signals, the photoelectric pulse sensor has the advantages of simple structure, no damage, as well as good repeatable. This paper discusses the design and implementation of the photoelectric pulse sensor. The principle and structure of the photoelectric pulse sensor The principle of a photoelectric pulse sensor According to the law of beer-lambert - bill (lambert beer), substance in a certain wavelengths of absorbance is directly proportional to the concentration of with him, when the constant wavelength of light to human tissue, through