功能建造6(沙济伦博士讲义分享).pptVIP

* * * * * From Jay Baron. * 这是硬碰软，形势一边倒。 奇怪的是结果比硬的更过。大概是测量误差了。 Figure 13 on page 21 shows a run chart for dimension #3 on the body side outer before and after assembly. This figure shows that even though the mean is away from nominal for four stamping runs, the assembly process is stable. However, when the mean shifted significantly closer to nominal at the start of the fifth run, the assembly variation increased. In this instance, maintaining a consistent stamping mean appears more important than the relative location of this dimension to nominal. 1-4批量时，虽然零件的值离开目标有距离，但是，装配后的组件还算稳定。可是，零件整修后，离