抽拉速度对高温合金DZ125定向凝固中缩松的影响.pdfVIP

学兔兔 May 2009 VoI．58 No．5 ·427· 一 ^ 、●u■^■ - ● ■ ■ ’ - 、●^ 、● ’-彳 {新材料·新T艺 { 、^，vn■～_●_^，●_^，● -，’ ●、— 一 抽拉速度对高温合金DZ1 25定向凝固中缩松的影响 冯广召，沈 军，邹敏佳，刘 林 (西北工业大学凝固技术国家重点实验室，陕西西安710072) 摘要：研究了不同抽拉速度下镍基高温合金DZ125定向凝固试样中显微缩松的分布、变化规律。结果表明，在一定抽拉速 度范围内0≤100 m／s)，随抽拉速度增加，定向凝固试样中缩松水平降低。v=50wm／s~试样中缩松水平约为v=5 o,m／s~缩 松水平的10％， =100 m／s时试样中的缩松水平约~v=50 m／s时缩松水平的70~／o~90％。随抽拉速度增大，一次枝晶间距和 二次枝晶间距减小，枝晶发生细化，抽拉速度对缩松水平的影响主要由枝晶间距的变化引起。 关键词：镍基高温合金；定向凝固；抽拉速度；显微缩松 中图分类号：TG132．32 文献标识码：A 文章编号：100l一4977(2009)05—0427—04 Influence of Withdrawal Rate on the Micro—Porosity of Super-Alloy DZ1 25 in Directional Solidification FENG Guang‘zhao，SHEN Jun，ZOU Min-jia，LIU Lin (State Key Laboratory of Solidification Processing，Northwestern Polytechnical University， Xi。an 71 0072，Shaanxi，China) Abstract：DirectionaI solidification experiments were carried out on nickeI based super-alloy DZ1 25 under withdrawal rates of 50 m，s，50 p．m／s and 1 0O m，s in order to investigate the distribution and variation of the micro．porosity．The results show that with the increasing of withdrawaI rate the micro．porosity leveI of the samples decreases．The micro．porosity IeveI at v=50 p,m／s iS about 1 O percent of that at v=5 p．m／s and the micro．porosity leveI at 1 O0 p,m／s iS about 70-90 percent of that at v=50 p．m／s．The primary arm spacing and the secondary arm spacing both decrease while the withdrawaI rate increases．The influence of withdrawal rate on the micro—porosity leveI depends on the arm spacing． Key words：nickeI based super-alloy；directionaI solidification；withdrawaI rate：micro-porosity 镍基高温合金DZ125具有良好的高温力学性能【I