Genesis steps(国外英文资料).docVIP

Genesis steps(国外英文资料) Genesis steps A Matrix production Take the standard 4-layer panel as an example, define the properties of each layer, and sequence the layers by the Ctrl b0 X command. (table 1). Drilling board drill positive Shape board rout positive The component surface character board silk_screen positive Component face resistance welding board solder_mask positive The component surface line, board signal positive Stratigraphic board power_ground negative The electrical layer board power_ground negative The welding face circuit board signal positive Weld face resistance welding board solder_mask positive The welding face character board silk_screen positive The proper alignment of the hierarchy is based on the following: A customer provides the order of hierarchy; There is a hierarchy of marks on the outside of the board; The c board has digital symbol identifiers such as 1, 2, 3, 4... It is. The general basis for judging every level of positive and negative is: The center of the welding disk is positive and the center of the welding disk is negative. Two orig production Orig is made up of three parts: Para 1 layer Production steps: A check all the layers, drilling into the reference layer, using the register function to make the circuit, geoelectricity, resistance welding and borehole to be automatically opposite. Other layers (including the character layer) need to move the entire layer by hand, allowing the outer border to overlap with the outer border of the elements surface layer and mirror when necessary. Inspection method: The center of a shall be aligned with the center of the borehole. The outside of b should overlap; The c element face character is the positive character and the welding face character is the reverse character. 2 line transfer pad Production steps: A opens the Features Histogram of the resistance layer and selects all the Lines in the Lines List. B at the same time, select and open the element surface lines and element surface res