Personal experience in PCB board format(国外英文资料).docVIP

Personal experience in PCB board format(国外英文资料) Author: wu ronghai (original 1.0) should be done in the following order every time a piece of PCB is designed, which will save time and obtain the best results. Select the name of the file such as SCH, PCB (in English, number), plus extension. The principle diagram is designed for the size of the size, the size of the drawing, the metric system, and the library element. It is easy to see how the elements and lines are drawn in accordance with the circuit function module. Try to be fair, beautiful, and dont walk in the inside of the device. Be careful not to walk in the middle of the pipe because there is no electrical connection. It is best not to let the two component pin connected directly, after the painting can be automatically numbered (special exception), then add the corresponding nominal value, the best nominal value changed to red, bold, so that we can distinguish and label. It is best to put the label and nominal value in the right place, usually the mark on the left, the nominal value on the right, or the above label, which is unlabeled. Its a habit of keeping in the process! First of all, make sure that the schematic diagram is completely correct, that the ERC check is correct, and then print the check. Second, it is best to understand the principle of the circuit and the high and low pressure. The size of the current; Simulation, number; The size of the signal; Size power blocks to facilitate the layout of the rear. 3. The production of PCB components library for a standard library and their common repository without packaging for production, must pay attention to the vertical view, pay attention to size, welding plate size, position, number, inner hole size, direction and measure (printing). Name in English, easy to look for good, had better have marked the size of the corresponding, so that the next available lookup (you can use the name and the corresponding size table corresponding to save). For commo