联想常用显示器进进工厂形式方法(国外英文资料).docVIP

联想常用显示器进入工厂模式方法(国外英文资料) B/O5 P 6. One of the menu functions in the user mode cannot be used, such as degaussing, locking the keyboard, etc. The image is blurred, sometimes with a character or left or right. The size of a character or icon is incongruent on the screen, large in some places, and in some places small. The display image is normal, but there is a clear pattern of mesh in one area. View the main performance parameters of the display, total hours of work, etc. Changing the way the monitor works, turning on the aging switch, and the OSD menu function selection. Why do you need to go into factory mode? Display USES the bus control mode of CNC, display the internal cancelled most of the adjustable potentiometer, the display wont appear in the process of using the failure caused by poor contact after the potentiometer oxidation, at the same time because of the I2C bus control, PCB wiring is more convenient, the connection between integrated circuit simulation display much less than before, more powerful, debugging is more simple, can easily realize the pincushion distortion of the image, barrel distortion, equal quadrilateral adjustment, Angle on the mat, the Angle of mat, rotation and other special function of adjustable, and balance of the black and white balance adjustment no longer use potentiometer to realize, only through the OSD menu can be completed. We all know that when we use a cell phone, we sometimes interrupt a conversation because the signal is too weak or too noisy. Similarly, in the process of computer work, if there are strong electromagnetic interference in the surrounding environment or because the line is too long cause signal attenuation in the process of transmission is too large, the receiver received signal error may occur. When the error rate is low or only the individual data bit is wrong, the system is not detected, and it is likely to be received and stored. This is why the display is so bright in the process of use, and the contr