主体结构工程施工方.docxVIP

MAIN STRUCTURE ENGINEERING WORK METHOD1、FORMWORKConsidering the factors that quantity of spares and scale of concrete are too big ,it is better to use plastic plywood and multiple splint as holders and Φ48 steel tube with hook bolts in formwork holding system . 1）、Principle of assembling the plate①keep accuracy of spare shape ,size and location②formwork suppose to have enough intensity, yield and stability , can bear the weight of newly poured concrete and side pressure .etc②Keep the structure simple for being ease to dismantle. ③choose general use and big formwork to make the species and quantity small. ④when formwork are vertically connected ,they supposed to be laid stagger。⑤should design and lay upholding system of formwork according to maximum loads of formwork and intensity of spares 2）、Steps of assembling formwork ①work out quantity of formwork and upholding system which are needed according to construction progress.②design assembling and confirm ways of assembling according to diagram ③arrange upholding system according to designing diagram of upholding.④measure location of pre-buried spares and holes to arrange them accurately .3）、beam boards to support formwork①material to choose：choose 25mm pinewood board as bottom of formwork；choose 18mm multilayer plywood as side formwork,50X70MM pine wood as holding board, bottom formwork choose 18mm thickness plastic plywood ,60x80mm pine wood boards as separating board ,space 300-400mm .②Laying：subsequence of laying: bearing structural formwork constructing-main boards adjustment-inferior bottom formwork adjustment-sides of formwork-side formwork fixing-construct bearing boards-laying cushion boards-seal checking holesAll the project use wooden formwork, width of outside structure beam surface decrease 5mm to inside.All beam which size of beam span more than 4 miters with arc 3-5‰4）、Formwork pillar constructionAssembly formwork molder according to pillar surface and choose the bigger one 5）、Dismantle of formwork ①wh