700MPa级热轧双相钢的组织和性能.pdf

21 8 Vol. 2 1, No. 8 2009 8 Jour nal of Ir on and Steel Research Augu st 2009 700 MPa , , , , ( , 100083 : SEM 700 MP a , : + , 730 MPa, 01 62, 231 6% , DP 700 , : ; ; ; ; : TG1421 1 :A : 100120963( 2009 082 00212 04 Microstructure and Property of 700 MPa GradeHot Rolled Dual Phase Steel H UANG Quan2wei, SONG Ren2bo, ZH OU Le2yu, FA NG Yuan , LIU Ya2zheng ( School of Mater ials Science and Engineer ing, Univer sity of Science and Technology Beij ing, 100083, China Abstract:The phase tran sformation rule of test steels and the microstructure evolution for different process parameters w ere investigated by u sing ther mal simulation, scanning electr on microscop e ( SEM . 700 MPa grade hot rolled dual phase steels wer e pilot2produced based on the results of thermal simulation , and the hot r olling and cooling p arameter s w ere also optimized . The r esults of exp eriments indicate that t he microstructure is compr ised of ferr ite and mar tensit e; ten sile strength is 730 MP a, yield ratio is 01 62, and elongation rate is 231 6% , rat io the tested steel r eaches the desired proper ties of DP 700 class of these steels. And the influence of coiling temper atur e on final mechanical pr op erty was discussed. Key ords: dual phase steel; microstr ucture; prop ert y; contr olled cooling; coiling temp erature , , , + , , , , DP700 , , 1 , 74% 11 1 [ 1] ( , % : C 01 064, + Si 01 65, Mn 11 08, Cr 01 57, Mo 01 36, Nb 01 04