克己USB延长线(国外英文资料).docVIP

自制USB延长线(国外英文资料) Homemade USB extensions - the stingy DIY DIY a lot of fun, so I always like to make some computers, computer peripheral equipment is now growing, keyboard, mouse, modem, printer, scanner, to the present digital camera, MP3 player, if only use the original serial or parallel port, is far cannot satisfy the need of, so in some of the more advanced the motherboard provides a USB interface. Many devices using the USB, my USB device is also a lot of, but some motherboard integrated USB interface is only two, if there is excessive use USB peripheral devices, these devices must be unable to work at the same time, had to take turns duty, in use process need often hot plug these devices. And integrated USB interface on the main board in the rear of chassis, some old case, nor has the front USB ports, and, if any, of the case is under the table, often in use had to bend the bow, put down the frame, under the table to drill to drill to plug USB cable, very inconvenient. Human natural inertia and the inconvenience of use may be to reform innovation power, so, want to take advantage of existing equipment, make a USB extension cable, to solve this awkward situation. Every device after add a SUB hub with an extension cord, although the line is not very expensive, but I have a lot of waste line, actually it can be used to make it a USB extension cord, ha ha, I mean enough, I was to make BT DIY! I have A plenty of A less known and inferior brand printers use USB cable (figure 1), one end is A head (rectangular), on the other side is B (square), due to other equipment form A complete set of data line, so there is no much use this USB cable, just can use it to make A USB extension cord. Figure 1 You also need a cheap USB extension card (figure 2). Figure 2 There are also tools for use: screwdriver, soldering iron, multimeter, etc. (figure 3). Figure 3 When the preparations are finished, you can begin. Making process First, cut off the B head of the USB cable, keep th