扫描图片削减容量方法(国外英文资料).docVIP

扫描图片缩小容量方法(国外英文资料) Scanning image to reduce capacity The image that the enterprise scan is bigger, the upload attachment is slower, the method that collects several kinds of image capacity shrinks. For reference only! One, through the systems own drawing tools: In the start menu -- the attachment -- draw the drawing board Click on the menu bar in the drawing board - open, select the path to open the image that needs to be narrowed The photos are so large that they tend to see only a fraction of them. This is just a waveform of a circuit that doesnt need such a high pixel. Select image in the menu bar - stretch/twist A window Select the appropriate proportions in both horizontal and vertical The image will be reduced by this ratio. You can see the whole picture, and you can still see the image clearly. Lets look at the file size again From 3M to 123K, it was a huge reduction. But its important to note that because this is a reduction in pixels, the image will be blurry if you zoom in. So a high-precision image cannot be reduced by this method. Second, reduce image capacity through photoshop: Make sure your computer is installed in PHOTOSHOP and use PHOTOSHOP to open the image. Select the cutting tool of the left-hand toolbar, and then cut out the sections that are needed in the image Click image drop box in the top toolbar and select image size and pop-up dialog box. 1) if your JPG file is A4 paper wide scan files, recommendations will be under the document size 19 cm, the width of the resolution set to 75 or 133 pixels per inch, select the good and confirmed, as shown in the figure below, the aim is to respect the image of the original size, as far as possible; If it is a camera, it is recommended to be 1024 * 768 pixels or 768 * 1024 (depending on the photo), select good and confirm, as shown below. Select the stored as WEB format in the file drop-down box; At this point, the dialog box on the right side of the screen sets up the dialog box to set the status of th