FX4800---匝道测量(国外英文资料).docVIP

FX4800---匝道测量(国外英文资料) CASIO fx -4800p is the version of the 7.0 version of the ramp version of the program: xus July 1, 2001 One, extended variable Settings instructions Count the number of factors Number of elements Ramp serial number 1 ramp 2 ramp 3 ramp 4 ramp 5 ramp Extended variable number The value of the non-ramp Number of cut points (including the end point) a1 a2 a3 a4 The a5 2 a + 3 - 3/2 Number of change points (including the end point) b1 b2 b3 b4 b5 3 b - 2 Two-thirds of the Ultra high number (including the end point) c1 c2 c3 c4 c5 2 c 0 Set the total number of extended variables: 2 (a1 + a2 + a3 + a4 + a5) + 3 (b1 + b2 + b3 + b3 + b4 + b5) + 2 (c1 + c2 + c3 + c4 + c5) + 74) Set the data for each extension variable The fixed variable and the free variable Z Fixed variables and free variables set tables location Set the content or value For note one The ramp number (1, 2, 3, 4, or 5, depending on the calculation) Must be set before run 2 The thickness of the surface layer Must be set before run 3 Half the width of the design width of the center Must be set before run 4 Semi roadbed width (inclusive of central separation zone) Must be set before run 5 Dirt road shoulder width Must be set before run 6 Minimum cross slope design value of dirt road shoulder Must be set before run 7 The free variables used in the program Dont set 8 The free variables used in the program Dont set 9 The free variables used in the program Dont set 10 73 Must be set before run 11 76 + 2 a1 Must be set before run 12 79 + 2 + 2 a1 a2 Must be set before run 13 82 + 2 a1 + a2 + 2 a3 Must be set before run 14 85 + 2 a1 + a2 + 2 a3 + 2 a4 Must be set before run 15 a1 Must be set before run 16 a2 Must be set before run 17 a3 Must be set before run 18 a4 Must be set before run 19 The a5 Must be set before run 20 85 + 2 a1 + a2 + 2 + 2 a3 + 2 a4 a5 Must be set before run 21 83 + 2a1 + 2a2 + 2a3 + 2a4 + 2a5 + 3b1 Must be set before run 22 81 + 2a1 + 2a2 + 2a3 + 2a4 + 2a5 + 3b1 + 3b2 Must