南工大化工原理《第二章流体输送机械》习题解答(国外英文资料).docVIP

南工大化工原理《第二章流体输送机械》习题解答(国外英文资料) The second chapter is the solution of the problem 1) a cylinder of liquid, with a vertical line of lead and a level of liquid, as shown in the dotted line. When the container moves in an equal angular velocity, omega is rotating around the axis of the container, the liquid surface is curved. Try to prove: The liquid face is a rotating paraboloid. (2). The pressure of a point in the liquid phase (r, z). Rho is the density of the liquid. The solution????? And the general formula for this is the general formula for the convolution in the liquid phase ????? (constant)????? In cylindrical coordinates, as shown in figure, when Z = 0, r = 0, P = P0, ∵ C = P0 So the cyclotron, the general type is (1)?????? The surface of the liquid is P = P0 So, Im going to rotate the paraboloid 2. again Namely: h0 = ∴ H = 2 h0 The pressure of a point (r, Z) P: 2) the diameter of 0.2 m, 0.4 m high hollow round barrel, filled with water in the cylinder, the center has holes through the atmosphere, surface and inside the lid side flush, as shown in the appended drawings, when the cylinder at 800 RPM speed around the axis of the container line, q: cylindrical wall in the liquid of the medial high and low pressure? The solution????????? ????? So if you take the cylinder coordinates, when Z is equal to 0, and r is equal to 0, P = P0? ∴ C = P0 ? So cyclotron, the general type is?? ? B: Z = 0, r = r = 0.1 m, C: Z = -0.4 m, r = 0.1 m,????????????????????????????????????????????????????? 3) the process of absorbing CO2 from the mixer in lye is shown in the attached diagram. Known: 0.45 at top pressure (gauge pressure), alkali lye tank liquid level and tower outlet vertical height difference of 10.5 m, lye flow is 10 m3 / h, iv specification is phi 57 x 3.5 mm, length, a total of 45 m (including local resistance equivalent length), alkali density, viscosity, wall roughness. Test: the shaft needed to transport each kilogram of mass lye, J/kg. The delivery of lye requires