卷板工艺(国外英文资料).docVIP

卷板工艺(国外英文资料) Ganjiang diqiao steel tower manufacturing in jishui county Process of plate roll plate DQ399 - GY - 01 To compile review audit China railway jiuqiao engineering co., LTD In March 2001 preface News in the paper of ganjiang bridge steel tower elliptic arc suppression method for outsourcing, specific pressure arc operation process and test requirement with reference to the China railway bridge engineering co., LTD. Nine volumes of enterprise standard 2 process. First, a test will be done before the relevant department is qualified to test the test pressure. One. Engineering profiles 1. The project profile Ji water gan second bridge project from news in ganjiang west city planning glorious west avenue, pile number K0 + 050, across the river and the binjiang road (green) lake avenue, JiYang road in the east end check Yu Wanli avenue, pile number K1 + 800. The route is about 1.75 km long, with 1.31 km of bridge and 0.44 km of connection. The main tower is the structure of the vertical independent two-box, the tower is above the platform above 90m, above the bridge level 67.064 m, the height of the bridge is 22.936 m. Pillar height direction points three section, pile caps is above 0 ~ 39.5 m for the concrete pillar, pile caps is above 39.5 ~ 44.2 m pillar for the steel mix segment, pile caps is above 44.2 ~ 90 m pillar for steel structure. The upper tower and the steel mix are 3.5 m for the length of the bridge. The top of the tower is 3m, the largest of which is 9.6 m. The outer contour line is used in the two sections of the arc of tangential arc. Figure 1-1 bridge layout The steel tower column is divided into 19 sections in the height direction, and the 0 # segment is a steel mix segment with a length of 4.7 m. Section 1 ~ 18 # section is the steel structure segment, the longest segment is 2.6 m, the shortest segment is 1.854 m. FIG. 1-3 steel tower column and elevation drawing 1-4 steel tower The project content: including steel pillar (including pillar s